TREADCOTE is designed to rejuvenate the appearance of heavily weathered or stained TREADMASTER Original. The product is easy to apply, full surface preparation and application details are shown on the can. Available in colours to suit TREADMASTER Original.

MRRP:

COLOUR:

COVERAGE:

£40.81 ex. VAT *

Fawn

1 Litre covers approx 7M² (1 coat)

MRRP:

COLOUR:

COVERAGE:

£40.81   ex. VAT *

Grey

1 Litre covers approx 7M² (1 coat)

MRRP:

COLOUR:

COVERAGE:

£40.81 ex. VAT *

White Sand

1 Litre covers approx 7M² (1 coat)

MRRP:

COLOUR:

COVERAGE:

£40.81 ex. VAT *

Blue

1 Litre covers approx 7M² (1 coat)

Treadmaster Paint

INSTRUCTIONS FOR USE

Surface Preparation

The Treadmaster Original must be completely clean, dry and free of any oil, grease or other contamination.

The surface should be prepared by gentle but thorough scrubbing with Treadmaster Cleaner (available direct from Tiflex) taking care to clean well into the surface profile, but avoiding damaging the pattern. Finally the Treadmaster should be thoroughly rinsed and allowed to dry.

Conditions

Ensure good ventilation throughout the operation.

Painting should only be undertaken in dry conditions at temperatures between 10°c and 25°c.

Application

The deck should be masked off around the sheet to prevent splashing.

Any splashes on surrounding surfaces should be wiped up immediately.

The Treadcote will settle during storage. Before use the container should be swirled gently from end to end for 5 minutes to ensure even dispersion of pigments. Do not shake vigorously. When ready for use the Treadcote should appear evenly coloured and have a thin creamy consistency.

Agitate occasionally during use.

For application to Treadmaster DP (diamond pattern) brush carefully along the grooves in both directions, without allowing the Treadcote to 'puddle', then for the most even finish, use a short pile gloss roller, worked well to remove excess Treadcote, to run lightly over the diamonds.

For application to Treadmaster SP (shallow textured surface) a short pile gloss roller is recommended for the best finish.

For either application method do not apply too thickly.

Wait until dry (normally 3 to 4 hours depending on conditions) before re-coating.

Do not walk on your Treadcote or allow it to come into contact with water for at least 4 hours and ideally 24 hours.

* Sensational Spring Special 25% off... you pay just £30.61 + VAT per litre.

Click to Return to our Home Page

Information in this document and otherwise supplied to users is based on our general experiences and is given in good faith but, because of particular factors which are outside our knowledge and control and affect the use of products, no warranty is given or implied with respect to such information.

Specifications are subject to change without notice. A safe handling data sheet on this material is available as a PDF download. Click here to download

Please contact our Webmaster with questions or comments. © Copyright 2008 Tiflex Limited. All rights reserved.

You are in...
About TIFLEX
Contact Us
Data Sheets (MSDS)
Distributors
Download a Brochure
How To Find Us
Abrasion Resistant
Acoustic Barrier
Anti-Fatigue Mats
Cricket Balls
Diving Board Covering
Machinery Mounting
Marine Products
Offshore Products
Rail Services
Specialist Flooring
Structural Bearings
Special Offers

ALL Prices are for UK ONLY.  For overseas pricing please contact us.

Treadmaster Marine spring offers are available to online customers ONLY. Promotions may end at anytime without notice.